Showing posts with label cassette changeover. Show all posts
Showing posts with label cassette changeover. Show all posts

Friday, 20 November 2026

Cable Tray Roll Forming Machines Explained: Workflow, Types and Real Specs

What is a cable tray roll forming machine? It is a continuous cold forming line that turns flat coil into finished cable tray sections, cut to length and ready for supports and covers. The metal is never heated. Each pair of rolls adds a small bend until the strip reaches the final profile.

The Line, Station by Station

Strip starts on a decoiler holding a 3 to 8 tonne coil, then passes through a 5 to 9 roll leveler to remove coil set. A servo feeder indexes it into a punch press that cuts ventilation slots and mounting holes while the strip is still flat. The forming stands, usually 12 to 22, shape the tray. An encoder triggers the cut off, and a run out table collects the finished lengths. Typical material ranges from 0.8 to 2.5 mm in 100 to 600 mm widths.

Punching Decides the Speed

At 12 pitches per metre and a 1.2 second press cycle, a hydraulic press delivers about 4 m/min. Rotary punching runs 10 to 15 m/min on a single repeating pattern. The widely quoted 60 m/min is the surface speed of the forming rolls with no punching and no cutting. Always ask for saleable metres per shift on your own coil.

Four Tray Types, Different Tooling

Solid bottom trough needs forming stands only. Ventilated tray adds a punch press and one die set per hole pattern. Ladder tray forms two side rails and welds on rungs, requiring a rung feeder and welder. Channel tray is a shallow single piece using fewer stands. Wire mesh tray is welded from wire and cannot be made on this line at all. One machine rarely covers all four.

Specs Worth Writing Down

A useful enquiry fixes strip thickness, width range, tray height, material grade, forming stand count, hole pattern, cut length tolerance and changeover time. Motorised width adjustment takes 20 to 40 minutes; a cassette change takes 2 to 3 hours. Factory acceptance should measure 20 consecutive parts for length and hole position.

Read the full article →

6 Changeover Checks That Separate Z Purlin Lines

Stopwatch, Not Brochure Buyers of a Z purlin roll forming machine are often shown the same numbers: 1.5 to 3.5 mm galvanized strip, webs fr...