Showing posts with label walkboard plank. Show all posts
Showing posts with label walkboard plank. Show all posts

Friday, 20 November 2026

Scaffolding Roll Forming: Five Profiles, Three Work Areas, One Clear Spec

A scaffold tower is mostly bent steel with holes in it: the plank underfoot, the ledger between posts, the toe board at the edge and the guardrail at waist height. All of them start as coil. Scaffolding roll forming makes those repeat profiles, but it does not make the whole system.

Five Profile Families

Walkboard planks run 210 to 250 mm wide in 1.2 to 2.0 mm galvanized strip through 16 to 22 stands, with anti-slip punching and end hooks. Ledger channels use 12 to 18 stands and welded lock cups. Toe boards are shallow, needing 8 to 12 stands. Guardrail channels use 14 to 20 stands plus a straightness check. Brace channels take 10 to 16 stands with angle notching. The plank is the hardest profile because it carries people.

Where Roll Forming Stops

Round standard posts and cuplock verticals are welded tube from a tube mill, not a roll former. Cups, rosettes and hooks are welded on after forming. A supplier claiming one line makes both is quoting two lines in one crate. Plan separate bays for tube work and roll forming.

Speed Comes From the Punch

A servo feed with hydraulic punch runs 10 to 15 m/min; mechanical or rotary punching reaches 30 m/min and above; flying cut off runs 20 to 35 m/min; and the stacker handles 15 to 25 m/min. Read the slowest station as the line speed. A line sized from the forming motor will stop at the press every cycle.

What the FAT Should Measure

Run the buyer's coil and produce at least 50 consecutive planks at contract speed. Check cross section at three points, hole pitch over 20 parts, cut length over 10 parts within plus or minus 1.5 mm over 3 m, edge straightness and a burr under 0.2 mm. Pitch drift of 0.3 mm per stroke is what makes hooks miss the ledger cups by 4 mm on site.

Read the full article →

6 Changeover Checks That Separate Z Purlin Lines

Stopwatch, Not Brochure Buyers of a Z purlin roll forming machine are often shown the same numbers: 1.5 to 3.5 mm galvanized strip, webs fr...