Showing posts with label top hat. Show all posts
Showing posts with label top hat. Show all posts

Thursday, 19 November 2026

3 in 1 Roll Forming Machine Passes Test, Ships for Solar Mounting

Three Profiles, One Front End

A solar plant that needs C purlins, U channels and top hat rails has usually had to buy three lines. This order goes another way. A 3 in 1 roll forming machine has passed final testing in our workshop and is crated for shipment to a solar mounting customer. One line covers all three sections from a single coil entry and one control station.

Seven Stations in the Line

The machine starts with a 5 ton hydraulic uncoiler, sized for the heavier coils common in solar mounting work. A leveler follows, because flat strip is critical when three profiles share the same entry. A servo feeder pulls to length and holds the strip while multiple punch stations cut slots and round holes at set pitches, without stopping between holes. An auto width adjustable roll forming machine then shapes C and U sizes from the panel, with no shims and no manual measuring on every change.

The Cassette Mill Is the Key

Each profile carries its own cassette of rolls. Switching from C to U to top hat swaps the tooling set while the stands stay in place. The buyer gets one uncoiler, one drive train and one floor footprint instead of three of each. Only one profile runs at a time, which fits a solar plant that batches mounting sections by project.

What Changed on This Build

The main upgrade is motorized top and side roller adjustment. Top hat sections need tight control of the web and both flanges. On a manual line, setting those gaps across ten stands takes time and skill. Here the operator sets gaps from the panel and the recipe repeats them on the next run. A flying hydraulic cutting device finishes the line, travelling with the strip so the machine never stops for a cut and the ends stay square.

Tested Before It Shipped

Every station was assembled, wired and run, not just inspected. Coil feed and leveling, punch pitch, auto width change, cassette swap, motorized roll gaps and flying cut length all passed. Test pieces from all three profiles are packed with the machine as first article samples. Our engineers will install and commission the line on site, then repeat the same checks on production coil before handover. Believe Industry has built custom roll forming lines since 2005, with 80 plus engineers, 500 plus projects and machines in 50 plus countries.

Read the full article →

6 Changeover Checks That Separate Z Purlin Lines

Stopwatch, Not Brochure Buyers of a Z purlin roll forming machine are often shown the same numbers: 1.5 to 3.5 mm galvanized strip, webs fr...