Ask a buyer to describe a bad pallet rack beam and you will usually hear two words: bow and twist. A beam that arches 2 mm over 3 m will not drop into the upright without force. One that rotates 2 degrees will not hold a pallet level. Getting rid of those faults starts with knowing where they come from.
Six Defects, Six Shop Limits
Step beam roll forming defects fall into six measurable families. Over a 3 m length our acceptance records use 1.5 mm for vertical bow, 1.0 mm for side camber and under 1 degree for twist. Edge wave on the step flange is capped at 0.3 mm peak to valley over 300 mm, step height at plus or minus 0.3 mm and end flare at 0.5 mm over the final 100 mm. A feeler gauge, a 3 m straightedge, a string line and two digital levels cover nearly every case.
The Coil Comes First
Coil problems produce more step beam defects than worn rolls. Crown in the strip pushes extra metal through one side of each stand, so the beam curves toward the short edge. Check 2 m of slit strip on a flat table before adjusting anything. A new supplier or a new heat number changes the reading on a line that ran clean for six months.
Small Gap Errors Multiply
A step beam spreads its bends over about 28 stands. A left-right roll gap difference of only 0.05 mm creates visible twist by the final stand, because every later stand inherits the error. Set the last stand first and work upstream one stand at a time, running three beams after each change. High strength coil at 350 MPa springs back 2 to 4 degrees, so the final two stands need a small overbend.
Do Not Reach for the Straightening Head
A straightening head presses a bad beam straight while leaving the cause in the pass schedule, and the fault returns on the next coil. Sag that vanishes when you add a third support is a run-out table issue. Twist that appears only after the connector weld is heat distortion. Neither is a forming defect.
No comments:
Post a Comment