Where Twist Comes From
Ask an operator why an upright column bows and the answer is usually new rolls. In most cases the rolls are fine. The pass design is not. A column runs 2 to 12 m, so a 0.5 degree error at the last stand becomes a visible bow at the end of an 8 m part. Good upright column roll tooling solves this at the design stage. Bad tooling adds straightening passes later and charges the plant in scrap every shift.
Pass Count Follows Thickness
For a standard teardrop column with a 50 to 100 mm web and 40 to 60 mm flanges, 2.5 mm steel starts at 14 passes, 3.0 mm at 16 to 18, 3.5 mm at 18 to 20, and 4.0 mm high bay work at 20 to 24. One punch station sits ahead of forming and rolls run at HRC 58 to 62. No pass should turn more than 10 to 12 degrees on 3 mm strip, or more than 8 degrees on 4 mm. The last 15 to 20 percent of passes exist to correct, not to form.
Spread the Angle
The first four passes take about 25 percent of the bend at 6 to 8 degrees each. The middle half carries about 50 percent at 8 to 10 degrees. Passes 15 to 18 recover springback at 2 to 4 degrees, and the final two carry 0 to 1 degree. Cold rolled 3 mm springs back 1 to 2 degrees after the roll releases. High strength low alloy at 4 mm can spring 3. Ignore that and every column lands slightly open.
Hold the Web Flat
Four flower rules do most of the work. Keep the web flat as the datum. Form both flanges together so side thrust cancels. Hold the roll gap at 1.05 to 1.15 times strip thickness. Never form and punch at the same station. Punch first, while the strip is flat and backed by a solid die block, and keep the hole edge at least 1.5 times thickness from a bend line.
Tool Steel and Lead Time
Cr12MoV at HRC 58 to 62 covers 2.5 to 3.5 mm. At 4 mm, D2 with deep cryogenic treatment lasts longer, and shafts need to be 90 to 120 mm to limit deflection. A 16 pass set with one pre punch station runs 35,000 to 70,000 USD. Lead time is 45 to 70 days from approved flower pattern, and that approval is the gate that decides everything else.
No comments:
Post a Comment